DC motor without "/>

What causes the DC motor not to start?

The number of clicks: Updated: 2017-09-23 15:49:09 [ close ] share:
    What causes the DC motor not to start?

    1.Power is missing

    Conditions that may be present: For example, the power switch is not closed, the front fuse is blown, the fuse of the motor main circuit or the control circuit is blown, the contactor and other power control equipment fails, and the line wire is cracked or loose. The processing method is the beginning of the early-stage fuse, and gradually check the wires and equipment of each part of the main circuit and the control circuit of the motor to find out the cause and correct it.

    2. Motor problems

    Possibly present conditions: severe brush wear, jamming, insufficient spring pressure, etc. make the brush and commutator poor contact; the armature winding is disconnected; the field winding is disconnected and there is no residual magnetism. The processing method is to disconnect the power supply, and check the contact resistance between the brush and the commutator with the resistance file of the multimeter, and the resistance at both ends of each winding. If the resistance value is too large to indicate the existence of the problem, look further and find the breakpoint to correct it.

    3. Mechanical problems

    The mechanical equipment or transmission organization of the motor is stuck, and the starting load is too heavy. At this point, you should quickly remove the power supply and look for mechanical problems.


    直流电机

    contact us


    Zibo Zemei Motor Co., Ltd.

    Phone: 15063395708

    Fax: 0533-6880533

    Address: Bei'an, Zhoucun District, Zibo City


    Zemei Electric Wenzhou Office

    Phone: 0577-88359304

    Fax: 0577-88359304

    Contact: 13017804983

    Address: Qiaoertou, Lucheng District, Wenzhou

    contact us