DC Geared Motors </ a "/>

How to adjust the spring of DC geared motor?

The number of clicks: Updated: 2017-11-25 14:48:11 [ close ] share:
    How to adjust the spring of DC geared motor ?

    1. Disconnect the power, open the box machine, loosen the box cover screws, and remove the box cover.

    Second, use a hexagonal wrench to adjust each tension spring screw, so that the permanent magnet DC geared motor controller achieves the best results when the rod is running.

    3. If there is a jitter phenomenon in the starting lever, it means that the tension of the balance spring is too large. Repeat the above operation.

    4. Connect the power supply of the channel brake, and press the up or down button of the controller to make the permanent magnet DC geared motor controller run 90 degrees up and down 4 to 5 times. The controller of the magnetic DC geared motor runs to the vertical state.

    5. If the permanent magnet DC geared motor controller is running and the permanent magnet DC geared motor controller does not operate when the rod is lifted, it indicates that the tension of the balance tension spring is insufficient, adjust the state of the tension spring or increase the tension spring until the permanent magnet DC reduction motor Device is operating normally.


    直流减速电机

    contact us


    Zibo Zemei Motor Co., Ltd.

    Phone: 15063395708

    Fax: 0533-6880533

    Address: Bei'an, Zhoucun District, Zibo City


    Zemei Electric Wenzhou Office

    Phone: 0577-88359304

    Fax: 0577-88359304

    Contact: 13017804983

    Address: Qiaoertou, Lucheng District, Wenzhou

    contact us