Adjust the speed by adjusting the DC gear motor spring

hit count: Updated: 2018-07-29 14:59:07 [ close ] share:

    The specific operations are:

    1. Disconnect the power, open the box machine, loosen the box cover screws, and remove the box cover.

    2. Use a hexagonal wrench to adjust each tension spring screw, so that the DC geared motor controller achieves the best results when the rod is running.

    3. If there is a jitter phenomenon in the starting lever, it means that the tension of the balance spring is too large. Repeat the above operation.

    4. Connect the power supply of the channel brake and press the controller's ▲ or ▼ key to make the DC geared motor controller run 90 degrees up or down 4 to 5 times. If the time bar falls, the vibration of the balance spring is insufficient. The controller runs to the vertical state.

    5. If the DC geared motor controller is running and the DC geared motor controller does not work when the rod is lifted, it indicates that the tension of the balance tension spring is insufficient, adjust the state of the tension spring or increase the tension spring until the DC reduction motor controller runs normally.

    According to the above description, the most important of the DC geared motor is the controller, which is the main used component of the DC geared motor to control the speed. The speed control of the DC geared motor controller is realized by the adjustment of the spring. This can help us to try to adjust the spring when the speed control of the DC geared motor is not obvious. This will effectively help us solve the root cause of the problem.

    contact us


    Zibo Zemei Motor Co., Ltd.

    Phone: 15063395708

    Fax: 0533-6880533

    Address: Bei'an, Zhoucun District, Zibo City


    Zemei Electric Wenzhou Office

    Phone: 0577-88359304

    Fax: 0577-88359304

    Contact: 13017804983

    Address: Qiaoertou, Lucheng District, Wenzhou

    contact us