How to install the governor of DC geared motor

hit count: Updated: 2019-08-21 16:10:08 [ close ] share:

    A DC geared motor is a rotating electrical machine that can convert DC electrical energy into mechanical energy or convert mechanical energy into DC electrical energy. Everyone should have contact with its governor. Due to its low noise and power saving characteristics, it has been widely used in industry. The result directly affects the use of DC motor governor.

    1. Connect the AC power line and connect the excitation voltage according to the positive and negative values, otherwise it will cause reverse.

    2. At the output of the main armature circuit, the + pole is connected to the positive pole of the DC motor main armature, and the-pole is connected to the negative pole of the main armature.

    3. The speed feedback + pole is connected to the positive pole of the speed generator feedback signal, and the speed feedback-pole is connected to the negative pole of the speed generator feedback signal.

    4. Place the DC geared motor case in a well-ventilated, non-corrosive gas place. Check whether the internal screws are loose due to transportation.

    5. Before operation, turn the manual adjustment potentiometer on the panel to the zero position. Then apply the power supply voltage and then turn the manual adjustment potentiometer knob.

    contact us


    Zibo Zemei Motor Co., Ltd.

    Phone: 15063395708

    Fax: 0533-6880533

    Address: Bei'an, Zhoucun District, Zibo City


    Zemei Electric Wenzhou Office

    Phone: 0577-88359304

    Fax: 0577-88359304

    Contact: 13017804983

    Address: Qiaoertou, Lucheng District, Wenzhou

    contact us