DC Geared Motors </ a "/>

Which items need to be checked before the DC geared motor is put into use?

hit count: Updated: 2017-07-01 16:07:07 [ close ] share:
    Which items need to be checked before the DC geared motor is put into use?

    Before the DC geared motor is put into use, it needs to be systematically tested to facilitate future use. The following are the 4 test items before it is used.

    1. Check whether the size of the hole (or shaft) connected to the DC geared motor meets the requirements. The tolerance of the hole should be H7 (the tolerance of the shaft is H6).

    2. Replace the plug at the highest position of the DC geared motor with an exhaust screw plug to ensure that the gas is expelled from the body when the DC geared motor is running.

    3. Note that the operating temperature of the DC geared motor is 0 ~ 40 ℃.

    4. The installation shaft should be cleaned before use. And check the installation shaft for any injuries and dirt, if there is any, it should be removed completely.

    The above briefly introduces the 4 testing items before the use of DC geared motors, I hope to be helpful to you.


    直流减速电机

    contact us


    Zibo Zemei Motor Co., Ltd.

    Phone: 15063395708

    Fax: 0533-6880533

    Address: Bei'an, Zhoucun District, Zibo City


    Zemei Electric Wenzhou Office

    Phone: 0577-88359304

    Fax: 0577-88359304

    Contact: 13017804983

    Address: Qiaoertou, Lucheng District, Wenzhou

    contact us