DC Geared Motors </ a "/>

How to solve the DC geared motor's speed regulation fault?

hit count: Updated: 2017-11-16 16:32:11 [ close ] share:
    How to solve the DC geared motor's speed regulation fault?

    1. Disconnect the power, open the box machine, loosen the box cover screws, and remove the box cover.

    Second, use a hexagonal wrench to adjust each tension spring screw, so that the DC speed motor controller achieves the best results when the falling rod is running.

    3. If there is a jitter phenomenon in the starting lever, it means that the tension of the balance spring is too large. Repeat the above operation.

    4. Connect the power supply of the channel brake and press the controller's ▲ or ▼ key to make the DC speed control motor controller run 90 degrees up or down 4 to 5 times. The speed motor controller runs to the vertical state.

    5. If the DC speed control motor controller is running and the DC speed control motor controller does not work when the rod is lifted, it indicates that the tension of the balance tension spring is insufficient, adjust the state of the tension spring or increase the tension spring until the DC speed control motor controller runs normally. .


    直流减速电机

    contact us


    Zibo Zemei Motor Co., Ltd.

    Phone: 15063395708

    Fax: 0533-6880533

    Address: Bei'an, Zhoucun District, Zibo City


    Zemei Electric Wenzhou Office

    Phone: 0577-88359304

    Fax: 0577-88359304

    Contact: 13017804983

    Address: Qiaoertou, Lucheng District, Wenzhou

    contact us